EZO bearings kit for rear MP2 hub

Pawls kit for MP4, MP6 and Edition One HD hub

Make sure to install the springs first then the pawls.

Bearing 61706-2RS for rear Gravity One hub

61706-2RS

Caps for rear Edition One SL centerlock &...

Pawls kit for SR5 hub

Make sure to install the springs first then the pawls.

Classic® and Edition One SL Freehub body

Available for: -Shimano® HG -Shimano® Microspline -Sram® XD -Sram® XDR -Campagnolo® N3W If your hub had a different freehub body than the new one you need to replace the right end cap as well....

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Aivee MT6, MP,6 Edition One HD rear hub endcaps

You cannot modify a Boost hub into non-boost. Reverse is also impossible.

Edition One Road Freehub body

Available for: -Shimano® 11spd  -Campagnolo® If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body including pawls,...

Pawls kit for MT3 hub

Make sure to install the springs first then the pawls.

Bearings kit for rear Edition One SL hub and...

6903-2RS SKF X2

Aivee MT6 front hub endcaps QR

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

MP4 freehub body

Available for Shimano 10/11V and Sram XDR/XD 11/12V

Edition One MTB Freehub body

Available for: -Shimano® 11s MTB -Sram® XD 12/12s If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body including...

Aivee MP2, MP4 rear hub endcaps

Aivee SR1, SR2, SR5 front hub endcaps

Caps for rear Edition One SL hubs & Classic®

Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...