
Set of ceramic bearings for Edition One SL
List of Swiss ceramic bearings : 2 x 6803-2RS (front hub) 2 x 6903-2RS (rear hub) if centerlock 1 x 6902-2RS + 1 x 6903-2RS 2 x 6803-2RS (freehub)
6903-2RS EZO X2
16 other products in the same category:
List of Swiss ceramic bearings : 2 x 6803-2RS (front hub) 2 x 6903-2RS (rear hub) if centerlock 1 x 6902-2RS + 1 x 6903-2RS 2 x 6803-2RS (freehub)
Make sure to install the spring first then the pawls.
Available for: -Shimano® 8/9/10 spd MTB -Sram® XD 11/12 spd If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body...
This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.
Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...
Available for: 9mm QR: KIT-5141 12x100mm: KIT-5142 15x100mm: KIT-5140
Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026
Make sure to install the springs first then the pawls.
End-caps are different either if you are using a Shimano® freehub body or a Sram XD freehub body Shimano®: 10mm QR: KIT-50 12x135mm: KIT-50 12x142mm: KIT-50 Sram® XD: 10mm QR: 12x135mm: 12x142mm: